Mutchus

This is a dual-output switch mode power supply reference design based on the MAX17116. The part and reference circuit can provide both negative and positive supplies to AMOLED displays. [via]   The MAX17116 includes two current-mode 1.4MHz switch mode power-supply (SMPS) regulators for active-matrix organic light-emitting diode (AMOLED) displays. The positive supply is provided by a step-up regulator with a synchronous rectifier. The negative supply is provided by an inverting regulator with a synchronous rectifier.[ ]

This is the simple Logic probe yields three discrete states circuit diagram .The circuit uses a dual LED. When power is applied to the probe throughthe power leads, and the input is touched to a low level or ground, Ql is cut off. This will cause Q2 to conduct since the base is positive with respect to the emitter. With Ql cut off and Q2 conducting, the green diode of the dual LED will be forward biased, yielding a green output.   Logic Probe Yields Circuit Diagram   Touching the probe tip to a high level will cause Ql and Q2 to complement, and the red diode will be forward biased, yielding a red output from the LED An alternating signal will cause alternating conduction of the red and green diodes and will yield an indication approximately amber. In this manner, both static and dynamic signals can be traced with the logic probe.

The LTM4620 is a dual 13A per output (or single 26A output) DC/DC μModule step-down regulator that delivers up to 100A when four devices are current shared. The LTM4620 is a complete DC/DC regulator system in a 15mm x 15mm x 4.41mm LGA package, including inductors, power stages and all control circuits. For optimum heat dissipation, an integrated top side heat sink removes heat quickly and evenly.[ ]

Simple Advance Burglar alarm from dual-op amp Circuit . Device such as burglar alarms and sirens, whose basic purpose is to monitor certain conditions, make enjoyable projects because of the verity of sounds they can generate. Figure 1 shows a simple siren/alarm circuit using a dual-amp MC1458, audio amplifier LM380, and a 1-W speaker. The dual op-amp is used as a signal generator that produces square, pulse and triangular or sawtooth wave froms. The operation of the circuit is as follows. The A1 and A2 op-amps make up a waveform generator in which the output of A1 is a square wave or pulse waveform and that of A2 is either a triangular or sawtooth waveform.  The potentiometer R2 controls the frequency as well as the type of output waveform of op-amps A1 and A2. The switch SW1 connect the output of A1 or A2 to the audio power amplifier LM380, this in turn drives the speaker. Although not used in the circuit of figure 1, a potentiometer may be connected between (+) and (-) inputs o...