Skip to main content

Posts

Showing posts with the label single

LTM4620 – Dual 13A or Single 26A DC DC µModule Regulator with Integrated Heatsink

The LTM4620 is a dual 13A per output (or single 26A output) DC/DC μModule step-down regulator that delivers up to 100A when four devices are current shared. The LTM4620 is a complete DC/DC regulator system in a 15mm x 15mm x 4.41mm LGA package, including inductors, power stages and all control circuits. For optimum heat dissipation, an integrated top side heat sink removes heat quickly and evenly.[ ]

single line diagram of simulated fault

Simplest Single Phase Preventor Circuit for Three Phase Motor Potection

For a 3-phase induction motor,Lit is necessary that all the three phases of supply are present while it is on load. When any one of the fuses goes out, or a phase is missing, the motor will continue to run with two phases only, but it will start drawing a huge current for the same load. This high current may ruin the motor, unless switched off immediately. A single phase preventor circuit avoids such a mishap. With this circuit the motor will not run, unless all the three phases are present. In a 3-phase supply, the voltages are 120 degrees apart from each other. Thus the addition of three phases gives zero voltage. lf any one of the phase goes, voltage present at the summing point equals half the line voltage. ‘ In this circuit, the three phases (R, Y, B) are connected to line neutral, which in turn is connected to the ground of the   circuit. When all three phases are present, voltage at point D is zero. So potential at pin 3 of 1C 741 is also zero, but voltage at pin 2 is ne...