Skip to main content

Properties and USB Capability



  • Easily connected to the computer because it does not need to open the computer cover. Uniform shape USB connector, there are only two forms of type socket.
  • Hot-plugable - that USB devices can be connected when the computer is on
  • Plug and Play - USB equipment that is easy to use, when connected to a computer, the computer will recognize the pick up program (driver) in accordance with the equipment.
  • Equipment that requires little resources, can take resources from the USB port. Resources off equipment when not in use.
  • High-speed data transfer, can reach 12Mbps.
  • One USB port can be connected with 127 tools.

    • Properties and USB Capability
    USB Cable 

  • Has a fault monitoring and data transmission will be repeated to ensure reliability of data.

    • Labels:

    Comments

    Post a Comment

    Popular posts from this blog

    PID instruction in Allen Bradley PLC Closed Loop Control

    PID instruction in Allen Bradley PLC [Proportional/Integral/Derivative] Closed Loop Control For   Processor SLC 5/02SLC 5/03SLC 5/04SLC 5/05    MicroLogix 1200 and MicroLogix 1500 (A special PID file replaces the old integer file control block.) Description of PID in PLC   This output instruction is used to control physical properties such as temperature, pressure, liquid level, or flow rate of process loops. The PID instruction normally controls a closed loop using inputs from an analog input module and providing an output to an analog output module as a response to effectively hold a process variable at a desired set point. The PID equation controls the process by sending an output signal to the actuator. The greater the error between the setpoint and the process variable input, the greater the output signal, and vice versa. An additional value (feed forward or bias) can be added to the control output as an offset. The result of the PID calculation (control vari...
    Post a Comment
    Read more

    NE566 Function Generator Circuit Diagram

    The NE566 Function Generator is a Voltage-Controlled Oscillator of exceptional linearity with buf fered square wave and triangle wave outputs. The frequency of oscillation is determined by an external resistor and capacitor and the voltage applied to the control terminal. The Oscillator CAN be programmed over a ten-to-one frequency range by proper selection of an external resistance and modulated over a ten-to-one range by the control voltage, with exceptional linearity.  FMAX = 1 MHz     WIDE 1000:1 Continuous Sweep Possible  NE566 Function Generator Circuit Diagram Pdf Datasheet  Sourced by : Circuitsstream
    Post a Comment
    Read more

    Long Loopstick Antenna Circuit Diagram

    Circuit Diagram  Description Wound on a 3 foot length of PVC pipe, the long loopstick antenna was an experiment to try to improve AM radio reception without using a long wire or ground. It works fairly well and greatly improved reception of a weak station 130 miles away. A longer rod antenna will probably work better if space allows. The number of turns of wire needed for the loopstick can be worked out from the single layer, air core inductance formula: Inductance = (radius^2 * turns^2) / ((9*radius)+(10*length)) where dimensions are in inches and inductance is in microhenrys. The inductance should be about 230 microhenrys to operate with a standard AM radio tuning capacitor (33-330 pF). The 3 foot PVC pipe is wound with approximately 500 evenly spaced turns of #24 copper wire which forms an inductor of about 170 microhenrys, but I ended up with a little more (213uH) because the winding spacing wasn't exactly even. A secondary coil of about 50 turns is wound along the length of th...
    Post a Comment
    Read more