General safety rules at school

1.0 Introduction

We are all mandated to ensure that the place in which we work is free from dangers associated with electricity, machines, materials and the tools we use. We cannot confidently perform our duties if we know that we are not safe. Therefore, this implies that we are all managers not only committed to support safety, but we must insist on electricity safety rules at school performance in a manner that is clearly understood and echoed at all cadres of life.

1.1 General Safety Rules

Accidents do not just occur; they are caused. To prevent them, always:
1. think before you act; if you are not certain please seek assistance;
2. concentrate on your work;
3. be mindful of your safety and the safety of others;
4. dress properly for the job to be done;
5. poise properly when carrying out a particular activity;
6. no horse-playing around in the place of work;
7. use the correct tools and machines for their intended job.
8. wear goggles, a face shield, gloves or some other safety device when you go around machines such as grinders or welders or when handling chemicals;
9. use only portable electrical equipment that have adequate earth connections. An earth connection is a protective wire that connects the metal frame of the portable electrical device with the earth wire.

A bad workman quarrels with his tools.

Comments

PID instruction in Allen Bradley PLC Closed Loop Control

PID instruction in Allen Bradley PLC [Proportional/Integral/Derivative] Closed Loop Control For Processor SLC 5/02SLC 5/03SLC 5/04SLC 5/05 MicroLogix 1200 and MicroLogix 1500 (A special PID file replaces the old integer file control block.) Description of PID in PLC This output instruction is used to control physical properties such as temperature, pressure, liquid level, or flow rate of process loops. The PID instruction normally controls a closed loop using inputs from an analog input module and providing an output to an analog output module as a response to effectively hold a process variable at a desired set point. The PID equation controls the process by sending an output signal to the actuator. The greater the error between the setpoint and the process variable input, the greater the output signal, and vice versa. An additional value (feed forward or bias) can be added to the control output as an offset. The result of the PID calculation (control vari...

NE566 Function Generator Circuit Diagram

The NE566 Function Generator is a Voltage-Controlled Oscillator of exceptional linearity with buf fered square wave and triangle wave outputs. The frequency of oscillation is determined by an external resistor and capacitor and the voltage applied to the control terminal. The Oscillator CAN be programmed over a ten-to-one frequency range by proper selection of an external resistance and modulated over a ten-to-one range by the control voltage, with exceptional linearity. FMAX = 1 MHz WIDE 1000:1 Continuous Sweep Possible NE566 Function Generator Circuit Diagram Pdf Datasheet Sourced by : Circuitsstream

Long Loopstick Antenna Circuit Diagram

Circuit Diagram Description Wound on a 3 foot length of PVC pipe, the long loopstick antenna was an experiment to try to improve AM radio reception without using a long wire or ground. It works fairly well and greatly improved reception of a weak station 130 miles away. A longer rod antenna will probably work better if space allows. The number of turns of wire needed for the loopstick can be worked out from the single layer, air core inductance formula: Inductance = (radius^2 * turns^2) / ((9*radius)+(10*length)) where dimensions are in inches and inductance is in microhenrys. The inductance should be about 230 microhenrys to operate with a standard AM radio tuning capacitor (33-330 pF). The 3 foot PVC pipe is wound with approximately 500 evenly spaced turns of #24 copper wire which forms an inductor of about 170 microhenrys, but I ended up with a little more (213uH) because the winding spacing wasn't exactly even. A secondary coil of about 50 turns is wound along the length of th...

Mutchus

Search This Blog